Racecap FastDry Beta front wheel bearing saver caps red kit

BEST PROTECTION AND DESIGN. ZERO FRICTION.

The wheel protection caps Racecap FastDry guarantee a longer life of the wheel bearings without causing further friction, they also improve the appearance: perfectly integrated lines and original colors.

COMPATIBLE WITH:

Beta RR 4T and 2T from 2013 on

Racecap FastDry are compatible with BETA wheels produced from 2013 on.

In order to mount the left front Racecap the original or aftermarket BETA diskguard should not be installed.

In order to mount Racecap Fastdry, wheels should be removed from the bike.

It is recommended to wash the wheels carefully, before mounting protections.

WARNING: Proper installation of Racecap requires them to be anchored to the spacer and released from the hub (the cap remains stationary while the hub rotates).

The Racecap can cause a squeak, it is not a defect.

This Racecap kit consists of No.2 specific protections for front wheel and adapters for BETA front wheel. The front cap is marked with the letter F (FRONT).

1) Remove wheel from motorcycle.

2) Clean and degrease spacers carefully and insert the adapter ring on the spacer as shown in the picture. The adaptor ring will keep the right position for mechanical interference; if necessary use cyanoacrylate glue.

3) Place the Racecap in the appropriate seat as shown in the picture.

Removing spacers from the wheel is not necessary to mount Racecap FastDry. Hint: take a ride with the bike after washing, to allow any small water deposit to exit from Racecap FastDry.

Frienduro disclaims every liability for damage caused by improper use of Racecap protections.

The product is guaranteed for manufacturing defects for two years, according to the law.

See also