Racecap FastDry KTM Husqvarna and Beta rear wheel bearing saver caps neutral kit

BEST PROTECTION AND DESIGN. ZERO FRICTION.

The wheel protection caps Racecap FastDry guarantee a longer life of the wheel bearings without causing further friction, they also improve the appearance: perfectly integrated lines and original colors.

COMPATIBLE WITH:

KTM EXC from 2002 with spacers produced in 2007 or later
KTM SX from 2002 to 2014 with spacers produced in 2007 or later (20mm wheel shaft)
KTM FREERIDE
Husqvarna FE/TE/FC/TC/TX from 2014 on (20mm wheel shaft) (*)
Husaberg FE/TE/FC/TC from 2002 with spacers produced in 2007 or later
Beta RR 4T and 2T from 2013 on
Beta XTraine
(*) not compatible with 25mm wheel shaft

Racecap FastDry are compatible with KTM wheels and spacers produced in 2007 or later; Husaberg from 2007 to the end of production; Husqvarna from 2014 on; BETA from 2013 on. KTM and Husaberg wheel hub is compatible for models from 2002 on, but spacers are compatible if produced in 2007or later. Racecap FastDry are not compatible with Husqvarna models previous to 2014. In order to mount Racecap Fastdry, wheels should be removed from the bike.

It is recommended to wash the wheels carefully, before mounting protections.

WARNING: Proper installation of Racecap requires them to be anchored to the spacer and released from the hub (the cap remains stationary while the hub rotates).

The Racecap can cause a squeak, it is not a defect.

This Racecap kit consists of No.2 specific protections forrear wheel for KTM / HSQ and BETA. The rear cap is marked with the letter R (REAR).

1) Remove wheel from motorcycle.

2) Clean and degrease spacers carefully and insert Racecap in the appropriate seat as

shown in the picture.

3) Removing spacers from the wheel is not necessary to mount Racecap FastDry. Hint: take a ride with the bike after washing, to allow any small water deposit to exit from Racecap FastDry.

See also