Racecap FastDry KTM rear wheel bearing saver caps kit

BEST PROTECTION AND DESIGN. ZERO FRICTION.

The wheel protection caps Racecap FastDry  guarantee a longer life of the wheel bearings without causing further friction, they also improve the appearance: perfectly integrated lines and original colors.

COMPATIBLE WITH:

KTM EXC from 2002 with spacers produced in 2007 or later
KTM SX from 2002 to 2014 with spacers produced in 2007 or later (20mm wheel shaft) (*)
KTM FREERIDE (*) not compatible with 25mm wheel shaft

Racecap FastDry are compatible with KTM wheels and spacers produced in 2007 or later; Husaberg from 2007 to the end of production, Husqvarna from 2014 on. KTM and Husaberg wheel hub is compatible for models from 2002 on, but spacers are compatible if produced in 2007or later.

Racecap FastDry are not compatible with Husqvarna models previous to 2014.

In order to mount Racecap Fastdry, wheels should be removed from the bike.

It is recommended to wash the wheels carefully, before mounting protections.

WARNING: Proper installation of Racecap requires them to be anchored to the spacer and released from the hub (the cap remains stationary while the hub rotates).

The Racecap can cause a squeak, it is not a defect.

This Racecap kit consists of No.2 specific protections for rear wheel for KTM / HSQ.

The rear cap is marked with the letter R (REAR).

1) Remove wheel from motorcycle.

2) Clean and degrease spacers carefully and insert Racecap in the appropriate seat as shown in the picture.

3) Removing spacers from the wheel is not necessary to mount Racecap FastDry.

Hint: take a ride with the bike after washing, to allow any small water deposit to exit from Racecap FastDry.

Frienduro disclaims every liability for damage caused by improper use of Racecap protections.

The product is guaranteed for manufacturing defects for two years, according to the law.

See also